High build, fast drying, anti-corrosive primer for steel. Contains zinc phosphate, corrosion – inhibiting pigment.
Coverage - 6sq metres per litre at 75 microns dry film thickness.
Drying Time @ 20°C - Touch Dry in 30 minutes. Dry to handle in 2-4 hours.
Re-coating - Red Oxide Primer can normally be recoated at any time after they are tough dry. However recoating times will vary according to ambient temperature, film thickness and relative humidity. We therefore recommend you always so a small test patch before over- coating. Do not apply at temperature below 5°C Application.
Conventional Spray - Thin up to 20% with BT1 thinner. Tip size 1.4mm – 2.0mm. Atomizing pressure 40-60 psi
Airless Spray - – Thin up to 5% with BT1 thinner. Tip size 0.38mm – 0.48mm - Atomising pressure 2000 psi
Roller - Use as supplied.
Brush - For small areas only Surface Preparation
Steel Blast cleaned to ISO SA2. Steel without mill scale.
Power-tool cleaned to minimum ISO- St2 Thinner - BT1 (thinning) BT2 (cleaning) VOC (supplied) - 500-550 grams per litre
Flashpoint - 23°C
Shelf Life - 12 months from date of manufacture in sealed containers. Store in a cool, dry place with temperatures between 5-30°C and in accordance with the Highly Flammable Liquids and Liquefied Petroleum Gasses Regulations 1972
DANGER
- Keep away from heat / sparks / open flames / hot surfaces. No smoking.
- Use explosion-proof electrical equipment.
- Do not breath vapours.
- IF ON SKIN (or hair) Remove / take off immediately all contaminated clothing. Rinse skin with water / shower
- IF INHALED. Remove victim to fresh air and keep at rest in a position comfortable for breathing.
- IF SWALLOWED. Immediately call a doctor / physician.
- Do NOT induce vomiting.
- Store in a well-ventilated place. Keep cool.
- Dispose of contents / container to hazardous waste.
Contains Xylene, 1-methyl-2-pyrrolidone
Data Sheet available on request